Toro has provided lawncare equipment since the early 1900s, and its electric trimmers have been popular sellers. The trimmers range from seven to 15 feet and are used by gardeners and homeowners to trim weeds and grass. While many characteristics of the trimmers have changed, the way to replace the trimmer lines has remained basically the same. All it takes is a trip to a home improvement store for the line and two minutes working the trimmer to get it back into action.
Removing the Old Line
Turn over the trimmer so the bottom is exposed.
Rotate the cap on the spool in a counterclockwise direction.
Remove the spool from the cutterhead.
If the spring falls off from the spool, place the spring back onto the spool.
Remove any leftover cutting line and throw it away.
Clean the cutter head and inspect for damage. Add WD-40 or some other mechanical grease to the eyelet.
Adding the New Line
Hook one end of the new line onto the slot on the spool. Allow no more than 1/8 inch to protrude through the top of the slot.
Wind the line between the spool flanges in a counterclockwise direction with the bump knob on the spool facing downward.
Hold the line and spool and fish the line through the eyelet on the cutterhead. Make sure no more than three inches of line protrudes from the eyelet.
Place the cap back on the cutterhead and rotate in a clockwise direction to tighten.