Damage to the fuel line is one of the most common problems on small engine gas trimmers such as the Weed Eater Featherlite. Luckily, with only about 30 minutes of labor and a few dollars you can fix this problem and greatly extend the life of your Featherlite. Fuel lines, if the trimmer is improperly stored, will corrode due to the dried gas that was left in the carburetor. You should always follow the owner’s manual suggested storage methods.
Get rid of any old fuel still in the tank. Drain it out into an appropriate container. Start it up and let the engine run until it dies. This will clear the carburetor of any old gas.
Locate the carburetor. The carburetor regulates fuel in the engine and is located just above the fuel tank and in-between the primer bulb and the spark plug. Use the screwdriver to remove the access cover and the primer bulb, in case you can’t easily reach the carburetor.
Look for two plastic fuel lines connected to the carburetor’s nozzles. Pull off the top line with the needle-nosed pliers. This is the line that runs to the tank.
Open the gas tank, reach in and pull out the fuel filter and fuel line, using the needle-nosed pliers. Pull them out through the tank and throw them away.
Cut off about 6 to 8 inches of new fuel line. Angle one end to a 45-degree diagonal. Insert the baling wire into the fuel line. Spread a little oil around the outside of the fuel line.
Thread the wire and line through hole at the bottom of the fuel tank. Keep pushing them until the plastic line pops out near the carburetor.
Grab and pull the line towards the carburetor using the needle nosed pliers. Snip off the angled end, but don’t connect it to the carburetor yet.
Snip off any extra line inside the tank. For the best results, leave two inches inside the tank. Push the new fuel filter’s nozzle into the fuel line.
Reattach the fuel line to the same nozzle you removed it from on the carburetor. Fill the trimmer with fresh fuel at a mix of 40:1 gas to oil.