Stepping stones can be a nice, decorative touch to add to your yard, but at the same time, they can be very functional. You can purchase these stones at home stores, but if you would like to save a little money and create a unique style and pattern, then making them yourself may be the answer. It is a fairly simple project that just requires some patience and creativity.
Decide what size and shape you want to use for your paving stone. You can use squares, rectangles, circles or just about any shape you can think of.
Purchase the form-shape you want. These can be found at home centers or garden supply stores. You can also build your own form shapes if you choose using 1-by-4-inch boards for the outside of the frame and a piece of plywood for the base.
Using petroleum jelly to coat the sides and base of your paving stone forms. This will keep the concrete from sticking to the form and make for easy removal once the concrete has set up and cured.
Cut a piece of the fabric mesh to fit the bottom of the form. Any type of mesh will work; cloth, metal and fiberglass are all good options. The concrete will be poured on top of the mesh, and when it cures, the mesh will provide strength to the stone.
Mix the quick-setting concrete with water, according to the directions on the package. You will want to make enough to fill the form with a little extra just in case you need it; it is better to have a little too much than not enough.
Pour the concrete into the form and on top of the mesh. Tap the sides of the form with the rubber hammer. This helps eliminate any air voids that may be trapped in the concrete that could compromise the strength of the cured product. Set it aside on a flat area, out of direct sunlight, and leave for at least 24 hours.
Remove the stones by turning the form upside down on the ground and tapping with the rubber hammer. The stone should slip right out.
Clean the stone with a wire brush to remove any loose pieces. Paint on the concrete sealer and set it aside to dry. If you do not seal the concrete, water will penetrate the stone and break it up over time. After 24 hours, the stone should be ready to be put in place.
Things You Will Need
- Paving stone forms
- Quick-setting concrete
- Fabric mesh
- Large bucket
- Trowel shovel
- Petroleum jelly
- Rubber hammer
- Wire brush
- Concrete sealer
- Install Garden Statuary
- Install Grasscrete
- Homemade Insulating Concrete
- Add Fiber to Concrete
- Make A/C Slabs
- Make a Tree Stump Bird Bath
- Design Concrete Fences and Foundations
- Install Gorilla Bottom Above-Ground Pool Floor Padding
- Pour a Concrete Roof
- Install Sign Posts
- Weld Aluminized Steel
- Build Concrete Driveway Tracks