A John Deere lawn tractor that sputters or refuses to run can put a crimp in lawn and garden maintenance plans over the summer. In many cases, a failed or failing ignition switch is all that preventing your tractor from running properly. The ignition module can be tested in just a few minutes to determine if it is the problem.
How the Ignition Module Works
On John Deere lawn tractors, the ignition module is the part that is responsible for creating the electricity used by the engine cylinder to ignite fuel and oxygen, which in turn powers the engine piston. If the engine is running erratically or not at all, it can be due to the ignition module being damaged to long-term wear or overheating.
Safely Park and Secure the Tractor
Prepare your lawn tractor for inspection by parking it on a hard, level surface. Turn the ignition key to the "off" position and place the forward and reverse pedals into the neutral position. Set the parking brake and place a wheel block under the right front tire. Raise the hood on the lawn tractor and secure it in the open position.
Locate the Spark Plug Wire
At the front of the engine, locate the spark plug wire that can be seen coming out of the shroud, and remove it from the spark plug. Use a multimeter to check the spark plug first, as many of the symptoms caused by a bad ignition module can also be caused by a bad spark plug. If the spark plug is good, continue on to check the ignition module. If it is bad, replace the spark plug and test the tractor. If the problem persists, continue on to test the ignition module.
Test the Ignition Module
Connect a spark tester to the end of the spark plug wire by attaching the alligator clip from the spark tester to the metal tip of the spark plug. Wear gloves in case a spark jumps while you are completing this step. Set the gap to 4.2mm on top of the spark tester by using the adjustment knob. Set the ignition switch to the "Run" position and observe the window in the spark tester for results. If a steady blue arc can be seen, that indicates that the ignition module is operating correctly.
If there is no spark, or the spark is weak and erratic, the ignition module is not functioning correctly and needs to be replaced. Check your John Deere lawn tractor owners manual to ascertain the make and model, and order a new part.
Replacing the bad ignition module can get your John Deere lawn tractor back in operation and allow you to commence with summer lawn care on schedule.
- Riding Lawn Mower Troubleshooting
- Troubleshoot the Weed Eater Excalibur 22
- Tell if a Coil on a Tiller Is Bad
- Diagnose Starter Problems for a John Deere Lawn Tractor
- Test a Lawn Mower Battery
- Repair a Scotts Lawn Tractor
- Adjust the Carburetor of a Weedeater SST25
- Install a Riding Lawn Mower Battery
- Troubleshoot a Bobcat 773G
- My Riding Mower Backfires & Has a Loss of Power
- Test the Cub Cadet 2135 Solenoid
- Echo String Trimmer Problems