Hi, this is John and in this clip we will be installing the pegs. I went ahead and purchased some shaker pegs from my home center and I'm going to be using these to hang the coats up on my coat rack. First thing, now that my glue has dried, holding my top plate and bottom plate together, I can go ahead and remove the screws. Now because I had pre-drilled those holes, to attach my two pieces together, I already have the location for each of the pegs. I just need to drill a little bit larger hole so that the peg will sit down in there so that I can glue it. I went ahead and installed a larger drill bit and now I just going to drill about three quarters of an inch. And then we'll go ahead and test it to make sure the peg fits and it seems to fit pretty nicely. Next we're just going to take a little bit of glue and put our peg in place and make sure you wipe off any excess glue. Go ahead and continue with the same procedure for the rest of the pegs.